Hallo, ich habe ein Problem mit meinem vServer.
Trotz (meiner Meinung nach korrekten) konfiguration ist der Server von ausserhalb nicht erreichbar.
IPv6-Subnet 2a03:4000:8:3da::/64
Code
auto eth0
iface eth0 inet static
address 37.221.192.191/22
gateway 37.221.192.1
dns-nameservers 46.38.225.230 46.38.252.230 2a03:4000:8000::fce6
iface eth0 inet6 static
address 2a03:4000:8:3da::1000/64
gateway fe80::1
ifconfig Ergebniss:
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 37.221.192.191 netmask 255.255.252.0 broadcast 37.221.195.255
inet6 2a03:4000:8:3da::1000 prefixlen 64 scopeid 0x0<global>
inet6 fe80::c875:e8ff:fe46:c2f0 prefixlen 64 scopeid 0x20<link>
ether ca:75:e8:46:c2:f0 txqueuelen 1000 (Ethernet)
RX packets 267581 bytes 17177363 (16.3 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 442 bytes 63642 (62.1 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1 (Lokale Schleife)
RX packets 165 bytes 14636 (14.2 KiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 165 bytes 14636 (14.2 KiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Alles anzeigen