Huhu erstmal...
Ich versuche seit gestern i wie meinen Server beizubringen das er auch eine IPv6 hat...
aber irgendwie gelinkt es mir nicht ...
in einen anderen beitrag hab ich nun wohl eine funktionierende interfaces gesehen...
meine interfaces sieht nun so aus:
Code
# This file describes the network interfaces available on your system
# and how to activate them. For more information, see interfaces(5).
# The loopback network interface
auto lo
iface lo inet loopback
# The primary network interface
allow-hotplug eth0
iface eth0 inet dhcp
iface eth0 inet6 static
pre-up modprobe ipv6
address 2a03:4000:2:24::2
netmask 64
gateway 2a03:4000:2::1
up modprobe ipv6
up ip -6 route add 2a03:4000:0:2::1 dev eth0
up ip -6 route add default via 2a03:4000:2::1 dev eth0
up ip -6 addr add 2a03:4000:2:24::2 dev eth0
Alles anzeigen
ifconfig zeigt mir das an:
Code
eth0 Link encap:Ethernet HWaddr 52:54:80:24:63:ee
inet addr:46.38.244.41 Bcast:46.38.245.255 Mask:255.255.254.0
inet6 addr: fe80::5054:80ff:fe24:63ee/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:26661 errors:0 dropped:0 overruns:0 frame:0
TX packets:324 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:1645867 (1.5 MiB) TX bytes:53267 (52.0 KiB)
Habe den Server danach per PowerOFF aus gemacht und auch neugestartet...
ip -6 ro
Code
fe80::/64 dev eth0 proto kernel metric 256 mtu 1500 advmss 1440 hoplimit 4294967295
default via fe80::4 dev eth0 proto kernel metric 1024 expires 0sec mtu 1500 advmss 1440 hoplimit 64
default via fe80::5 dev eth0 proto kernel metric 1024 expires 0sec mtu 1500 advmss 1440 hoplimit 64
default via fe80::6 dev eth0 proto kernel metric 1024 expires 0sec mtu 1500 advmss 1440 hoplimit 64
default via fe80::1 dev eth0 proto kernel metric 1024 expires 0sec mtu 1500 advmss 1440 hoplimit 64
Hab ich i was vergessen?
viell. wäre es ja auch machbar das netcup im wiki mal schön erklärt wie man die ipv6 am besten aufm server am laufen bekommt